Rebar cutting machine safety operating procedures

1. The working table for receiving and feeding materials should be kept level with the lower part of the cutter, and the length of the working table can be determined according to the length of the processed material.

2. Before starting, it is necessary to check that the cutter should have no cracks, the bolts of the knife holder are fastened, and the protective cover is firm, then turn the pulley by hand, check the meshing gap of the gears, and adjust the gap between the cutters.
3. After starting, idle first, and check the normal operation of each transmission part and bearing before working.
4. When the machine does not reach the normal operating speed, it is not allowed to cut the material. When cutting the material, the middle and lower part of the cutter must be used, and the steel bar should be firmly grasped and aligned with the cut to send it quickly.
5. When cutting the short material, the distance between the hand and the cutter should be kept more than 150mm. If the grip end is less than 40mm, the short end of the steel bar should be pressed or clamped with a sleeve or clamp.
6. If it is found that the machine is not running normally, there is abnormal noise or the cutter is skewed, it should be stopped immediately for maintenance.
7. After the operation, use a steel brush to remove the sundries between the cutters, and clean and maintain the whole machine.
8. It must be operated in strict accordance with the operating procedures.